Item Tag: JTAG-HS3

BRAND NEW Digilent JTAG HS3 Programming Cable AMD Xilinx FPGA Features Small, complete, all-in-one JTAG programming/debugging solution for Xilinx FPGAs and SoCsPlugs directly into standard Xilinx JTAG 2.0 mm pitch headerSeparate Vref drives JTAG signal voltages; Vref can be any voltage between 1.8V and 5VHigh-Speed USB2 port that can drive JTAG bus up to 30Mbit/sec (frequency adjustable by user)Compatible with Xilinx ISE® 14.1 and newer, Xilinx Vivado® 2013.3 and newerUses USB Micro-B connectorOpen drain buffer on pin 14 allows debugging software to reset the processor core of Xilinx's Zynq platform The JTAG-HS3 is an affordable high-speed Xilinx® FPGA programming solution. The HS3 builds on the successful JTAG-HS1 by adding an open-drain buffer to pin 14 allowing for the debugging of Xilinx Zynq-SOC processors. It can be attached to target boards using Xilinx's 2x7 connector*, and is compatible with all Xilinx tools, including iMPACT™, ChipScope™, and EDK. When connected to a PC via a standard A to micro-USB cable, the JTAG HS3 receives its power from USB and can be recognized as a Digilent programming cable, even if the HS3 is not attached to the target board. The JTAG bus can be shared with other devices as the HS3's signals are held in high-impedance, except when actively driven during programming. The HS3 is small and light, allowing it to be held firmly in place by the system board connector. Buy with Confidence - 20+ Year Seller - 100% Positive Feedback Message Questions Thanks for Looking!