Item Tag: Foxconn

This listing includes the following: Thirty (30) IEEE 802.11 b/g/n 1x1 AIOT ModuleManufacturer: Foxconn (Branded with Sharp logo)Part Number: FPWB-B434DRKZCondition:BRAND NEW! Never Used or Installed! Modules are from a bulk case - direct from the factory - there is no individual retail packagingThe Foxconn B01-02 s a low profile, low power and high performance AIOT moduleThese have the Sharp brand logo and the following part number: FPWB-B434DRKZBulk quantities available.FREE Shipping in the United States!USA Seller!In-Stock! Ships within ONE BUSINESS DAY of payment!The Foxconn B01-02 s a low profile, low power and high performance AIOT module. It is mainly consisted of Wireless IOT IC RTL8711AM, codec ALC5640 and 8MB flash for developing IOT application RTL8711AM is a highly integrated single-chip low power 802.11b/g/n Wireless LAN (WLAN) network controller. It combines an ARM-Cortex M3 MCU, WLAN MAC, a 1T1R capable WLAN based, and RF in a single chip. It also provides a bunch of configure GPIOs which are configured as digital peripheral for different applications and control usage. ALC5640 is a high performance, low power, dual I²S interface audio codec. Asynchronous Sample Rate Converter (ASRC) provides independent and asynchronous connections to different processors, such as an application processor, baseband processor or wireless transceiver. Alc5640 have stereo Class-D Speaker amplifiers provide 1.5W per channel into 8Ω or 2.5W per channel into 4Ω with a 5V supply, with excellent PSRR and low EMI. Characteristics: IEEE 802.11 a/b/g/n compatible WLAN72.2Mnps receive and transmit PHY rate using 20MHz bandwidth150Mnps receive and transmit PHY rate using 40MHz bandwidth802.11i(WPA,WPA2). Open, shared key, and pair-wise key authentication servicesWiFi WPS supportWiFi Direct support1 set of I2C interface1 set of log UART with standard baud rate supportI2S with 8/16/24/32/48/96/44.1/88.2KHz sample rateMono BTL(Bridge-Tied-Load) Class-D amplifier PCB Specification: Board-maker: Foxconn Material of the board: FR4Model number: 1P-1173X00-40SBBoard-thickness: 1.0mm (typ)Product-height: 5.45mm (max)Tolerance: 0.1mmFlame class: UL94V-0 This device is intended only for OEM integrators under the following conditions: 1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2) The transmitter module may not be co-located with any other transmitter or antenna. As long as 2 conditions above are met, further transmitter test will not be required. However, the OEM integrator is still responsible for testing their end-product for any additional compliance requirements required with this module installed IMPORTANT NOTE: In the event that these conditions can not be met (for example certain laptop configurations or co-location with another transmitter), then the FCC authorization is no longer considered valid and the FCC ID can not be used on the final product. In these circumstances, the OEM integrator will be responsible for reevaluating the end product (including the transmitter) and obtaining a separate FCC authorization. End Product Labeling: This transmitter module is authorized only for use in device where the antenna may be installed such that 20 cm may be maintained between the antenna and users. The final end product must be labeled in a visible area with the following: “Contains FCC ID: RX3-B01”. The grantee's FCC ID can be used only when all FCC compliance requirements are met. Please contact us with any questions. Thank you, EJC Ventures, LLC